centonm.com

UHT Milk production line

Milk sterilized under 135-140℃ for 4-10 seconds, products physicochemical index reaching commercial aseptic request,therefore it can be stored for a long shelf time under ordinary storage condition Applications: *Plain milk *Color milk *Syrup *Beverage *Other special products Advantage: *3m tubular heat exchanger, smaller installation area *Conform to EHEDG code *All wetted parts material is SS316L, …

UHT Milk production line Read More »

Pasteurized milk Production line

Pasteurized milk takes fresh milk as ingredient, pasteurized then get final products. The pasteurized temperature is 72-85℃, bacteria are killed but still keep milk nutrition and good taste at the same time. After centrifugal、filter、fat standardization、homogenizer、pasteurization and cooling, then filled and supply to consumers through cold chain.  General processing as below, 1. Raw milk reception and cooling …

Pasteurized milk Production line Read More »

tomato Sauce production line

System composition: Each effect heater、each effect separator、 condenser(mixing type or surface type)、each effect forced circulation pump 、 condensate pump、vacuum pump、liquid transfer pump、 platform、electrical instrument control cabinet, level automatic control system and valve&pipe fittings, etc.   Product features: 1. The equipment material properties to adapt to the wide range of processing. Mainly for evaporation process easy fouling materials, …

tomato Sauce production line Read More »

DTB Cooling crystallizer,OSLO Crystallizer

DTB Cooling crystallizer,Cooling Crystallizer ,DTB Crystallizer,OSLO Crystallizer( Draft tube baffle crystallizer)* Introduction to DTB crystallizerDTB crystallizer is a typical modern industrial continuous crystallizer, which is most widely used. It is the best continuous crystallizer whether it is vacuum evaporation, vacuum flash cooling or direct contact freezing. It is composed of heating chamber (or cooler), crystallization chamber, circulating …

DTB Cooling crystallizer,OSLO Crystallizer Read More »

External Circulation evaporator

* System composition:Heater, separator, condenser (mixed or surface type), feed pump, discharge pump, vacuum pump, condensate pump, operating platform, electrical control cabinet, level control system and valve pipeline, etc. * Working principle:The solution in the natural external circulation evaporator depends on the density difference circulation of the feed liquid: the liquid is heated in the heating chamber tube, …

External Circulation evaporator Read More »

 Forced circulation evaporator

What is Forced Circulation Evaporator Forced Circulation Evaporator Engineering Guide for High-Viscosity Liquids Forced circulation evaporator uses a pump to drive liquid at high velocity through a heat exchanger, preventing boiling on the heating surface. The heated liquid then enters a flash chamber where evaporation occurs. This design minimizes fouling, scaling, and crystallization, making it …

 Forced circulation evaporator Read More »

Falling fall evaporator

FALLING FILM EVAPORATOR

What is a Falling Film Evaporator? A falling film evaporator forms a thin liquid film (0.1–0.5 mm) on vertical tubes, enabling rapid evaporation with very short residence time. Falling Film Evaporator’s Key Performance Data Heat transfer coefficient: 2000–5000 W/m²·KResidence time: 5–30 secondsVacuum level: –0.08 to –0.095 MPaEfficiency: 20–40% higher than forced circulation Advantages of Falling …

FALLING FILM EVAPORATOR Read More »